Operation/Maintenance - Permobil Remote Stopping Device Owner's Manual

Remote Stopping Device
Operation
Remote Stopping Device
Beginning operation
The remote device's receiver receives power from the chair and is switched off
and on using the chair's power switch on the panel.
m WARNING!
Always check that the remote stopping device is functioning before use.
Stopping/locking the chair
Press the button on the remote control marked "I" for approximately 0.5s.
Unlocking the chair
Unlock the chair by pressing the button marked "I" on the remote control for
approximately 0.5s. On chairs with R-net or Pilot+ electronics the main power
switch on the chair's control panel can be switched off and then on again to
unlock the chair.
On chairs with Pilot+ and VR2 electronics the remote device may be fitted with
constant current, in which case it is not possible to unlock the chair using the
main power switch on the chair's control panel. See page 11 for more informa-
tion on this type of connection.
Chairs with the remote stopping device fitted using the battery connection cables
always have constant current and cannot be reset using the main power switch.
Maintenance
Cleaning
The parts of the remote device can be cleaned using a damp cloth. Soapy water
may be used for any stubborn marks on the surface. Dry the metal parts with a
towel after cleaning.
m WARNING!
Never hose down, as the electronics may be damaged.
35
United Kingdom