Table of Contents
Advertisement
2-10 Cam Assembly Adjustment
The cam assembly P#(A0422), which controls the
blower belt tension, comes from the factory pre-adjusted.
If the belt is too tight or becomes too loose, remove the
hair pin clip P#(K0099) from the belt tension rod
P#(K0326) and pull the "L" end of the rod out of its hole
in the cam assembly. The tension rod may then be
screwed out to tighten the belt or screwed in to loosen
the belt. Replace the "L" end into the top hole in the cam
and replace the hair pin clip. Adjust the cam stop bolt
P#(K1159) to allow the cam to rotate slightly over center
when the blower is disengaged (Figure 2-10).
Figure 2-10
Cam Stop
Bolt
2-11 Boot Installation
First, remove the deflector shield by pulling out the
locking pin and lifting the shield out of deck mount tube.
To install the boot to the mower deck, attach the boot
plate mount pin P#(B0274) to the boot plate P#(B0285)
using (1) 3/8"-16 x 3/4" HHCS P#(K1190) and (1) 3/8"-16
lock washer P#(K0048) See figure 2-11a. Next, loosely
fasten the boot P#(E1125) to boot plate using (2) 3/8"-16
x 1" carriage bolts P#(K1182) and (2) 3/8"-16 flange nuts
(P#K1215) with the head of the bolts placed from the
inside of the boot. Insert the boot plate mount pin into
the deck mount tube and slide the slot of the boot plate
over the tab at the top of the discharge opening. Place
the deflector shield in the transport position on top of the
boot plate. Replace the locking pin. Adjust the boot to fit
securely against the discharge opening and tighten the
(2) 3/8"-16 flange nuts. See figure 2-11b for clarity.
Cam Assy.
Tension Rod
Figure 2-11a
(1) 3/8"-16 x 3/4" HHCS
Boot Plate
Mount Pin
Figure 2-11b
Boot
Tab
Note: When bolting the boot and boot plate together,
the head of the bolt is placed from the inside of the boot.
This will prevent grass from collecting on the bolts.
Note: The Mower's Deflector Shield Has Been
Removed In The Following Photo For Clarity. Always
have the deflector shield mounted when mowing.
15
(1) 3/8" Lock Washer
Boot Plate
(2) 3/8"-16 x 1" Carriage Bolts
(2) 3/8" Flange Nuts
Boot
Locking
Plate
Pin
Exhaust Deflector
in Transport Position
Advertisement
Table of Contents
