Table of Contents
Advertisement
2-8 Universal PTO Installation
To mount the PTO assembly, insert the mount rod on the
PTO assembly P#(A0623) into the mounting slots
located on the PTO mount plate assembly P#(A0630)
Figure 2-8a. Next, tilt the PTO assembly forward and
insert the PTO assembly mount pin P#(B0274) thru the
hole in the top of the PTO mount plate assembly and
thru the PTO assembly. Secure the PTO mount pin using
1/8" x 2-1/2" hair pin clip P#(K0086) Figure 2-8b.
Figure 2-8a
PTO Mount Plate Assembly
Mount Rod
Figure 2-8b
PTO Assembly
Mount Pin
PTO Assembly
1/8"x 2-1/2"
Hair Pin Clip
14
2-9 Belt Installation
Loosen the (4) bolts P#(K1191), (2) on each side, that
secure the gear box assembly to the PTO assembly
P#(A0423) (Figure 2-9a). Loosen the adjustment bolt
P#(K0348) until the gear box assembly is at its far left
adjustment (the gear box is moved toward the mower's
engine pulley). Connect the A55K kevlar cord belt
P#(M0248) from the engine pulley to the lower gear box
pulley (Figure 2-9b). To tension the drive belt, turn the
adjustment bolt clockwise until there is 1" of deflection,
with 10-11 lbs. of pressure, at the center of the belt
between the engine pulley and the gear box pulley. Once
the correct tension of the belt is achieved, tighten the (4)
bolts that secure the gear box assembly.
Figure 2-9a
Loosen These
(4) Bolts
Adjustment Bolt
Figure 2-9b
Gear Box Assembly
Engine Pulley
Advertisement
Table of Contents
