ASCOM d41 User Manual page 53

User Manual
Ascom d41 DECT Handset
1
Figure 10. Easy Replacement Procedure via the DC4 Advanced Desktop ChargerI
1 On the new handset, press and hold
Note: Do not release
2 Put the new handset in the charger.
3 When the text "Start phone replacement?" is displayed, release
Press "Yes" (left soft key).
The text "Follow the instructions. Each step can take several minutes." appears in
the display. Press "OK"(left soft key).
4, 5 When the text "Please insert old phone in charger" is displayed, replace the new
handset with the old handset. The handset can either be switched on or off.
Note: If the CR3 Rack Charger is used, the same charging slot has to be used for
both handsets.
The handset will be restarted and after a few seconds, the text "Saving settings. Do
not remove phone from charger" appears. The charger LED changes to slow
orange flashing.
IMPORTANT: Do not remove the handset while the text "Saving settings. Do not remove
6, 7 When the text "Please insert new phone in charger" is displayed, replace the old
handset with the new handset. The text "Restoring settings" is displayed.
IMPORTANT: Do not remove the handset while the text "Restoring settings" is
8 When the text "Phone successfully replaced. Please remove phone to restart."
appears inthe display, remove the handset from the charger. The handset is
automatically restarted.
2009-12-15/ Ver. C
New
New
2 3
until you are instructed to do so.
phone from charger" is displayed. It may take several minutes
displayed.
New Old
4, 8 7 5 6
TD 92582GB
.
49