ASCOM d41 User Manual page 47

User Manual
Ascom d41 DECT Handset
Operational Problems
Fault
No display
No ringing
Error or Warning Messages
Display shows
No access
No System. The
handset beeps once a
minute (during max 30
minutes) with a low
tone followed by a
high tone (if enabled,
the vibrator also
follows the beeps).
SERVICE NEEDED
Parameters corrupt
Note: This display
message is only shown
in English.
SERVICE NEEDED
Invalid IPDI
Note: This display
message is only shown
in English.
Enter PIN code
Battery low, charge
now
Phonebook is not
available at the
moment.
Voice mail number not
defined
2009-12-15/ Ver. C
Probable cause
The battery level is low or the
handset is defective.
The sound off icon is on, or ringer
volume set to silent, or the
handset is defective.
Probable cause
The network is in range, but no
access rights.
The handset is out of coverage or
handset is defective.
Faulty handset.
Easy replacement procedure not
followed correctly or failure
during easy replacement
procedure.
The handset's lock is activated.
The battery level is low.
The phonebook does not
respond, not available at the
moment.
There is no Voice mail number
defined in the handset.
TD 92582GB
Action or comment
Charge the battery or contact
system administrator.
Long press the Sound off key,
or increase volume, or contact
system administrator.
Action or comment
Switch handset off and then
switch it on again or contact
system administrator.
Stop the beep with the Sound
off key and go into range.
Note: When re-entering the
coverage area it can take a
couple of minutes before the
handset automatically has
registered into the system.
or
contact system administrator.
Select the reset option on the
middle soft key and upgrade
the handset's software to
version 3.0.0 or greater. If this
is not available or the problem
persists send the handset for
service.
Send the handset for service.
Enter the required PIN code. If
PIN code lost enter new via
PDM or do a factory reset via
PDM.
Charge or replace the battery.
Try again later or if fault
persists do a factory reset via
admin menu or PDM.
Define a Voice mail number via
PDM.
43