Table of Contents
Advertisement
Factory Default
Factory default deletes all data entered into the phone after it was shipped to the factory. Before selecting yes,
make sure you want to delete all data.
NOTE: User-level access (no admin access) cans only factory default user level data.
Upgrade (Admin only)
Use this screen to upgrade the firmware of the Wi-Fi Phone.
The Wi-Fi Phone is pre-configured with the correct Download URL (web address of the download site) and OS Image
File (firmware upgrade file) entries.
NOTE:
Do not change these settings unless your Internet phone service provider
has given you new settings.
Plug the USB mini-B connector of the included power adapter into the USB mini-B port of the Wi-Fi
Phone. Then connect the power adapter to a standard electrical outlet.
NOTE:
If the upgrade is interrupted, the Wi-Fi Phone will revert to its old
firmware, and you can attempt the upgrade again.
Select Upgrade to start upgrading the Wi-Fi Phone's firmware, or select Return to cancel the
upgrade and return to the previous menu.
When the upgrade is complete, the Wi-Fi Phone will automatically power itself off. Wait five seconds,
and then power on the Wi-Fi Phone.
54
Chapter 4: Configuring the Wi-Fi Phone
Figure 4-72: Factory
Default settings
Figure 4-74: Upgrade
Figure 4-73:
phone
Upgrade phone
Advertisement
Table of Contents
