Avaya 4600 Series Installation Manual page 99

4. When control is passed to the software that was just loaded, the following messages
display:
Starting...
Updating boot code...
DO NOT UNPLUG THE
PHONE!
This message continues while the new boot code is being written into RAM.
Note:
Unplugging the telephone while the flash memory is being erased and the boot
Note:
code rewritten can cause file corruption.
5. The telephone detects and displays the speed of the Ethernet interface in Mbps, that is, 0,
10, or 100. The message No Ethernet displays until the software determines whether the
interface is 10 Mbps or 100 Mbps.
Note:
The Ethernet speed indicated is the LAN interface speed for both the telephone
Note:
and any attached PC.
6. The software determines whether sufficient IP Address information was downloaded. In this
scenario, it is discovered that sufficient information has not been downloaded. The
following message displays while the DHCP process is invoked:
DHCP: 0 secs
* to program
Note:
The number of elapsed seconds is incremented once per second, until DHCP
Note:
successfully completes. and any attached PC.
!
Important:
If necessary, invoke the local administrative ADDR procedure for static
Important:
addressing by pressing * at any time while the prompt * to program displays.
However, PROCSTAT must be zero and PROCPSWD must be null to invoke the
ADDR local procedure.
7. The following message displays while the TFTP or HTTP process is invoked:
TFTP: n
www.xxx.yyy.zzz
The number increments once per second, until the TFTP or HTTP server responds.
HTTP: n uri
Scenarios for the Restart Process
Issue 7 July 2008 99