Installing The Flywheel Guard - Keiser M3I Installation And Operation Manual

M3i INDOOR GROUP CYCLE
3. Align the holes of the flywheel with the holes of the hub.
NOTE: The flywheel should be flush against the hub.
4. Install the hubcap:
a) Align the holes of the hubcap with the holes of the
flywheel, refer to Figure 4.
b) Hold the flywheel in position.
c) Use the five, M6x1x20 SS socket head cap screws
(supplied) and a 5 mm Allen wrench and tighten
the screws.
d) Be sure the flywheel is flush against the face of the
hub. Spin the flywheel to make sure the it runs true
and straight (no wobbling).

INSTALLING THE FLYWHEEL GUARD

NOTE: When installing and centering the guard, try to avoid touching the flywheel with the guard.
1. Remove the two Allen screws and washers from the base
frame, refer to Figure 5. Do not discard the screws. They
will be used to mount the flywheel guard.
2. Place the open end of the flywheel guard over the
mounting stud located on the frame of the cycle, refer to
Figure 6.
3. Swing the guard over the flywheel, refer to Figure 7.
Figure 6. Flywheel Guard Placement
p08.
Figure 4. Flywheel and Hubcap Installation
Figure 5. Remove the Allen Screws
Figure 7. Center Flywheel Guard Over Flywheel