Installing The Pedals - Keiser M3I Installation And Operation Manual

M3i INDOOR GROUP CYCLE
4. Attach the brackets on the end of the flywheel guard, refer
to Figure 8. Use the M6 x 1 x 45 hex head screw and nut
(supplied). Hand tighten the screw and nut.
5. Tighten the brackets to the base frame with the two Allen
screws and washers removed in step 1. Do not fully
tighten the bolts.
6. Check to ensure that there is enough clearance between
the flywheel and the flywheel guard.
7. Using 2, 10 mm wrenches and a 5 mm Allen wrench,
tighten the bolt and screws to secure the flywheel guard
centered with the flywheel.

INSTALLING THE PEDALS

WARNING: Failing to install the pedals with a thread locking compound, or crossing the threads will
damage them, and could result in serious injury to the user.
NOTE: A torque wrench with 4 inch extension and 15 mm crowfoot are required to correctly torque the pedals.
1. Unwrap the pedals and the Loctite 242 - thread locking
compound.
2. Clean the threads of the pedals with a clean cloth.
3. Apply thread locking compound to the pedal threads.
4. Use a 15 mm open-end wrench and install the pedals:
Left Pedal - Thread the left pedal (marked L) into the
left side of the left crank arm by turning it counter-
clockwise, refer to Figure 9.
Left Bottom
Bracket
Bearing
Torque: 45 Nm
(35 ft-lbs)
Figure 9. Installing the Left Pedal, Turn Counter-
Clockwise
Figure 8. Align, Attach, and Tighten Flywheel
Guard Brackets
Right Pedal - Thread the right pedal (marked R) into the
right side of the right crank arm by turning it clockwise,
refer to Figure 10.
5. Tighten the pedals with a torque wrench, 4 inch
extension, and 15 mm crowfoot. Torque the pedals to
45 Nm (35 ft-lbs).
6. Apply LPS#3 to the left bottom bracket bearing.
7. Apply LPS #3 to the clip-in portion of the pedals.
Figure 10. Installing the Right Pedal, Turn Clockwise
Torque: 45 Nm
(35 ft-lbs)
p09.