Download  Print this page

Tools Required For Assembly - Keiser M3I Installation And Operation Manual

Indoor cycle.
Hide thumbs

Advertisement

M3i INDOOR GROUP CYCLE
INTRODUCTION
Thank you for purchasing Keiser's premier M3i indoor cycle. Your new resistance system is a revolutionary way to
exercise providing a smoother, quieter, and more predictable workout.
WEIGHT AND FOOTPRINT
Total Weight
M3i Footprint
ASSEMBLY
1. Carefully remove the cycle from the box.
2. Carefully unwrap the cycle.
WARNING: Use caution when using a box cutter or other tool with a sharp blade to unwrap the
cycle. A sharp tool can cause damage to the seat, handlebar, or scratch the frame of the cycle.
3. Layout all the cycle components and compare them to the "Parts List" on page 5.
4. Check that all parts are present and undamaged.
NOTE: If parts are missing or damaged contact your local dealer, distributor or Keiser Corporation Service
Department.

TOOLS REQUIRED FOR ASSEMBLY

The following tools are required to assemble the cycle but not supplied:
Qty
Description
1
Torque wrench (Minimum 45 Nm/35 ft-lb)
1
4 inch extension
1
15 mm open-end wrench
1
16 mm, or 5/8 inch open-end wrench
1
#2 Phillips screwdriver
1
15 mm crow foot
2
10 mm wrenches
p04.
91 lbs (41.27 kg)
Length 60.5 inches (1537 mm) x Width 25.75 in (654 mm)
Qty
Description
1
16 mm, or 5/8 inch crowfoot
1
5 mm Allen wrench
1
6 mm Allen wrench
Paste or spray wax (used to clean after
1
assembly)
1
Clean cloth
LPS #3 heavy-duty rust inhibitor
1
with straw

Advertisement

   Also See for Keiser M3I

   Related Manuals for Keiser M3I

Comments to this Manuals

Symbols: 0
Latest comments: