Mounting The Cycle To The Base; Installing The Flywheel And Hubcap - Keiser M3I Installation And Operation Manual

M3i INDOOR GROUP CYCLE

MOUNTING THE CYCLE TO THE BASE

NOTE: Due to the weight of the cycle, it is recommended that two
people perform this part of the assembly.
1. Align the holes of the cycle with the studs of the base,
refer to Figure 1. The front of the cycle should face the
wheels of the base.
2. Place the cycle onto the base.
3. Insert a washer (supplied) on each of the four studs.
4. Install an acorn nut (supplied) on each stud and then
hand tighten the acorn nuts.
5. Torque the acorn nuts to 45 Nm (35 ft-lbs) using a 16 mm
or 5/8" crowfoot attached to a torque wrench.

INSTALLING THE FLYWHEEL AND HUBCAP

WARNING: Failure to follow these instructions may cause damage to the flywheel.
1. Place the shifter lever in the downward position, refer
to Figure 2.
Figure 2. Shifter Lever Position
Figure 1. Cycle and Base Alignment
2. Slide the flywheel between the two magnets and over
the hub, refer to Figure 3.
Figure 3. Location of Magnets
p07.