Printing Guide (Example) - Partex ProMark MK9 Quick Start Manual

PRINTING GUIDE (EXAMPLE)

Printing the following contents on the tube/profile.
Tube size=Ø3. 2 mm
U1
1pcs.
18mm
★ Set "MATERIAL = TUBE" and "SIZE = 3.2mm" beforehand in the [PRINTED MATERIAL
setting screen]. (Choose another size if you don't have a 3.2 mm tube/profile).
[INPUT screen] appears. Make sure that LOCK has been turned ON.
(1)
Press /
Press PITCH to set "PITCH LENGTH."
(2)
Press key to set "18.0."
/
Note:
It is also possible to input the value by
pressing Ten keys.
After the setting is completed, press ENTER.
Press RPT to set "REPEAT."
(3)
Press key to set "1."
/
Note:
It is also possible to enter the value by
pressing Ten keys.
After the setting is completed, press ENTER
Press key to move the cursor behind
(4)
After inputting U and 1 , press BLOCK to
create a new block.
(5) The same as (3), press RPT to set "Repeat" to "5," and then press ENTER
(6) After inputting C , O and M , press
BLOCK to create a new block.
Quick Start
Pitch length= 18mm
COM
5pcs.
18mm
key to move the cursor to
X1005 X1006
2pcs. 2pcs.
18mm 18mm
.
.
Doc:
MK9-M-04-02
29
Sidan/ Page:
X1007
2pcs.
18mm
２ ０ . ０ Ｃ Ｕ Ｔ
P B
Ｐ Ｉ Ｔ Ｃ Ｈ Ｌ Ｅ Ｎ Ｇ Ｔ Ｈ
＝ １ ８ . ０ ｍ ｍ
１ ８ . ０ Ｃ Ｕ Ｔ
P B
Ｒ Ｅ Ｐ Ｅ Ａ Ｔ ＝
１ Ｐ Ｃ Ｓ
１ ８ . ０ Ｃ Ｕ Ｔ
Ｕ１
P B
B
Ｔ Ｕ Ｂ Ｅ ３ ． ２ ｍ ｍ
Ａ Ｕ Ｔ Ｏ Ｓ Ｔ Ｄ Ｓ Ｔ Ｄ
１ ８ . ０ Ｃ Ｕ Ｔ ０ ０ ３
Ｕ１ ＣＯＭ
B
Ｔ Ｕ Ｂ Ｅ ３ ． ２ ｍ ｍ
Ａ Ｕ Ｔ Ｏ Ｓ Ｔ Ｄ Ｓ Ｔ Ｄ
０ ０ １
０ ０ １
０ ０ ２
０ １
B
０ ５