HAKO Scrubmaster B310 R CL/TB 1020 Instruction Manual page 107

Maintenance and Service
Disassembling the cylindrical brush
The cylindrical brush can only be ac-
cessed from the right-hand side of the
machine, viewing to the front.
1
2
Fig. 40
1 Adjusting device for sweeping pat-
tern
2 Knurled screw for brush swing arm
3 Knurled screw for 
brush space cover
4 Brush space cover
5 Brush swing arm
1. Sit on the driver's seat, insert the key
in the key switch and turn to
position 1.
2. Press the button to switch pre-
sweep/vacuum unit on/off (Fig. 20/4)
to lower the side brush and cylindri-
cal brush.
3. Turn the key switch to position 0 and
remove the key. The cylindrical
brush and side brush remain low-
ered.
3
4. Pivot the right-hand side flap up.
5. Unscrew the knurled screw for the
4
brush swing arm (Fig. 40/2).
6. Pull off the brush swing arm
(Fig. 40/5).
5
7. Unscrew the knurled screw for the
brush space cover (Fig. 40/3).
8. Remove the brush space cover
(Fig. 40/4).
9. Pull the cylindrical brush out.
Installing the cylindrical brush
The cylindrical brush must be installed
in the reverse sequence to disassem-
bly, refer to Section "Disassembling the
cylindrical brush".
107