System Reset - Roberts classic blutune User Manual

System reset

If your radio fails to operate correctly, or some digits on the display are
missing or incomplete carry out the following procedure.
1. Press and release the On/Off button to switch on the radio.
2. Press and hold the Menu button.
3. Rotate the Tuning control until 'SYSTEM' shows on the display. Press
and release the Tuning control.
4. Rotate the Tuning control until 'RESET' shows on the display. Press
and release the Tuning control.
5. Rotate the Tuning control until 'Y' appears on the display. If you do
not wish to carry out a system reset, highlight 'N' and then press and
release the Tuning control. The display will revert to the previous
display.
6. With 'Y' displayed, press and release the Tuning control. A full reset
will be performed. The station list and presets will be erased. Settings
will be set to their default values. The radio will then restart as when
fi rst plugged in (see also page 5).
In the event of a malfunction due to electrostatic discharge, mains power
supply transients or short interruptions, reset the product as above to
resume normal operation. If you are not able to perform the reset operation
as above, removal and reconnection of the power supply and batteries
may be required.
1
2
3-6
32