Yamaha Motif XF6 Owner's Manual page 75

FW16E
1
Turn the power of the MOTIF XF off, and
disconnect the AC power cord. Also, make sure to
disconnect the MOTIF XF from any connected
external devices.
2
Remove the cover for the FW16E from the rear
panel.
With the rear panel of this synthesizer facing you, remove the
two screws from the cover.
Important
Keep the removed screws in a safe place. They will be used when
installing the FW16E. Be careful not to misplace them. Keep the cover
and fixing screws in a safe place for future use.
CAUTION
After removing the cover, you will see the metal fittings at the bottom
of the opening. To avoid cutting or scraping your fingers, be careful
not to touch them when installing the FW16E.
3
Insert the FW16E along the guide rails.
Push the FW16E all the way into the slot so that the
connector at the end of the FW16E is correctly inserted into
the connector inside the slot.
Guide rails
4
Replace the cover with the two screws you
removed in step 2 above.
NOTICE
Malfunctions or incorrect operation may occur if the FW16E is not
properly fastened.
For information on connecting to a computer, refer to "Using
the IEEE1394 terminal" on page 57.
Installing Optional Hardware
75
MOTIF XF Owner's Manual