Correcting Wrong Notes - Yamaha Motif XF6 Owner's Manual

2
Press the [ARPEGGIO ON/OFF] button so that the
lamp lights.
3
Press the [] (Record) button to enter the Song
Record mode.
4
Press the [F1] button to call up the Record Setup
display.
Recording Track
5
Set the following parameters in the Record Setup
display.
5-1
To select the desired track, press the [TRACK] button (the
lamp lights), then press the appropriate Number button
[1] – [16].
5-2
Set the Time Signature to "4/4."
5-3
Set the Quantize parameter to "off."
6
Press the [F2] button to call up the Record
Arpeggio display.
Arpeggio
Switch
Voice with
Arpeggio
Arpeggio
type
selection
7
Set the following parameters as required in the
Arpeggio Record display.
7-1
Set the Switch parameter to on.
7-2
Set the Voice with Arpeggio (ARP) parameter to on.
When this is set to "on," the Voice matching the selected
Arpeggio type is automatically called up each time the
Arpeggio type is changed.
7-3
Select the Arpeggio type by specifying the Category, Sub
Category and Type.
Time Signature
Quantize
8
After completing recording setup, press the [R]
(Play) button to start recording.
Press the [R] (Play) button so that its indicator flashes, then
actually start recording after the count-in.
9
When you reach the end of the above notation,
press the [] (Stop) button to stop recording.
If you've played any wrong notes, press the [] (Stop)
button, then try recording again.

Correcting wrong notes

If you've played any wrong notes while recording and wish to
correct them, press the [EDIT] button from the Song Play
mode to go to the Song Edit mode. Song Edit lets you clean
up and edit data of already recorded Songs or insert new
data to the Songs.
Check for any mistakenly recorded or wrong events on the
Event List display of the Song Edit mode, then correct them
as needed.
1
Select the recorded Song then press the [EDIT]
button to enter the Song Edit mode.
The Event List display appears.
2
Select the track to be edited.
Press the Number button [1]. The list of the MIDI events
recorded in the previous section appears on the display.
NOTE
Various MIDI events as well as note on/off data are shown on
the display if you operate controllers such as Pitch Bend
wheel, knobs and sliders while recording.
Gate time
Location Notes
3
Use the Cursor buttons to move the cursor to the
location to be edited.
After confirming the location at which the wrong data is
recorded, use the Up/Down Cursor button to move the
cursor to the location, then use the Left/Right Cursor button
to move the cursor to the data type to be corrected. For
example, if you recorded a wrong note data at the 2nd note
of the 3rd beat, move the cursor to the location indicated
MEAS (measure) = 002, BEAT = 03 and CLOCK = 240.
Then, move the cursor to NOTE if you wish to correct the
note data and move the cursor to GATE if you wish to correct
the gate time (note length).
NOTE
Each key has a note name; for example, the lowest (farthest
left) key on the keyboard corresponds to C1 and the highest
(farthest right) key to C6. See page 10.
Creating an original Song
Velocity
Selected track
MOTIF XF Owner's Manual
39