Foot Control; Slide-On Table; Seam Guide - Bernina 880 Manual

Sewing preparation

Foot control

2
3

Slide-on table

1
20
Connecting the foot control
⦁
⦁
⦁
1
Sewing speed control
Control the sewing speed by pressing the foot control 2.
4
Raising or lowering the needle
⦁
6 5
►
In the Setup-Program additional functions for the «back heel kicking» can be
programmed.
Removing the foot control
⦁
⦁
The slide-on table increases sewing surface.
Attaching the slide-on table
⦁
►
⦁
►
⦁
Removing the slide-on table
⦁
⦁
⦁

Seam guide

⦁
Can be moved over the entire table length.
034791.51.04_2014-02_Manual_B880_EN
unwind the cable
plug the cable in the outlet 1
unwind the cable to the desired length and slip into 4 or 5
sink the heel back 3 on the foot control
the needle adjusts the position up/down
wind the cable around the reel
plug cable into 6
USA/Canada only: Use only foot controller type LV-1 with
sewing computer B 880.
turn the handwheel or press the «Needle stop up/down»-button
(see page 15)
needle is raised
press «Presser Foot lift»-button
presser foot is raised
slide table to the right, over the free arm until it engages
ATTENTION!
Remove the slide-on table only when bobbin cover is closed.
raise the needle and presser foot
press button 1 down
pull slide-on table to the left
press the release button and insert into the groove (underside of table) from
left or right