Preparing for embroidery
Embroidery hoop
2
156
1
034791.51.04_2014-02_Manual_B880_EN
Center determination
⦁
determine the location of the center of the design within the fabric
⦁
mark the material with a fabric marker or chalk
Using the embroidery hoop
⦁
loosen the screw 1 of the outer hoop if necessary
⦁
remove the inner hoop
Match the arrows 2 of both hoops.
The arrows are
̶ on the oval and medium hoop at the center front
̶ on the small hoop to the right side
̶ with the Mega-Hoop, the Maxi-Hoop and the Jumbo-Hoop at the front in the
center (optional accessory)
Embroidery template
̶ there is an embroidery template for each hoop
̶ the embroidery area is marked in 1 cm squares
̶ the center and end point are marked with holes
⦁
for transferring marks to the material
⦁
attach the embroidery template holder
⦁
place the template in the inner hoop, so the BERNINA logo is at the front
edge (by the arrows) and can be read
►
in this position the embroidery template clicks into the inner hoop
Hooping the material
⦁
place the material under the inner hoop
⦁
line up the marked center point on the center of the template
⦁
place the material and inner hoop on the outer hoop
Match the arrows of both hoops.
⦁
fit hoops into each other; ensure that the material does not move
⦁
hoop the material to be embroidered tightly
⦁
tighten the screw
⦁
remove the template from the hoop by using the template holder