Cleaning/Update; Calibrating Buttonhole Foot No. 3A; Updating The Sewing-/Embroidery Computer - Bernina 880 Manual

Cleaning/Update

1 2
4 5
2
⦁

1 Calibrating Buttonhole foot No. 3A

2 Updating the sewing-/embroidery computer

3 Cleaning the thread clamp/Thread catcher
4 Lubricating sewing-/embroidery computer
5 Packing position
3
6 Setting the clock
6
Calibrating Buttonhole foot No. 3A
⦁
⦁
⦁
►
►
The Buttonhole foot No. 3A is calibrated to this sewing computer and should
only be used on this sewing computer.
Updating the sewing-/embroidery computer
⦁
⦁
It is recommended to save the data and the settings of the sewing computer
before the update is carried out.
⦁
►
⦁
It is then checked if:
1
3
►
After the successful update a message appears and sewing-/embroidery
computer is ready for use.
►
If the data and the settings aren't on the sewing computer anymore after the
update:
⦁
►
034791.51.04_2014-02_Manual_B880_EN
touch the «Cleaning/Update»-icon
touch the «Calibration»-icon
attach Buttonhole foot No. 3A
press «Start/Stop»-button
the Buttonhole foot No. 3A moves forward and backwards
the Buttonhole foot No. 3A is calibrated and the sewing computer indicates
whether the calibration has been successful
ATTENTION!
Do not remove the BERNINA USB stick until there is a message
which indicates the end of the update.
insert BERNINA USB stick with the new software version
touch the «Update»-icon
touch icon 1
the data of the sewing computer is saved on the USB Stick
touch the «Update»-icon 2 to start the procedure
►
a BERNINA USB stick is inserted
►
there is enough free space available
►
the correct software version is on the stick
the data and settings are accepted
if the update cannot be started or if there are problems during the update
process, an error message appears
touch icon 3
the data on the stick are saved on the sewing computer
Setup-Program
63