Table of Contents
Advertisement
The serial port of the Switch default setting is set to 9600 baud using a character format of 8 data bits,
no parity, and 1 stop bit.
Therefore, configure the terminal or workstation to use these settings before you log on to the
SGSW-2620. You can change this default setting, if desired, after you log on.
3.2.2 Remote Console Management
You can manage the SGSW-2620 remotely by having a remote host establish a Telnet connection to
the SGSW-2620 via an Ethernet or modem link.
Using this management method:
The SGSW-2620 must have an Internet Protocol (IP) address.
The Remote Console Management interface is identical in appearance and functionality to the Local
Console Management interface described in the previous section.
3.2.3 Web Management
You can manage the SGSW-2620 remotely by having a remote host with web browser, such as Mi-
crosoft Internet Explorer or Netscape Navigator.
Using this management method:
The SGSW-2620 must have an Internet Protocol (IP) address accessible for the remote host.
3.2.4 SNMP Management
You can manage the SGSW-2620 across a LAN using an SNMP Network Management Station with a
graphical user interface.
This management method lets you monitor statistical counters and set switch parameters from the
remote Network Management Station.
Using this management method:
- The network must run the IP protocol.
- The SGSW-2620 must have an IP address.
3.3 Assigning an IP Address to the Switch
To manage the SGSW-2620 remotely through the console port or with an SNMP Management Station,
you must assign an IP address to the SGSW-2620.
You assign IP address through the IP Settings screen. This procedure is described in Chapter 4, Section
IP Configuration. It is strongly recommends you assign an IP address to the default VLAN (VLAN ID = 1)
for Remote Console Management and SNMP Network Management.
3.4 Logging on to the SGSW-2620
When you log on to the SGSW-2620 console port for the first time, a sign-on string appears and you are
prompted for a console login user name and password.
24-port 10/100 + 2 Gigabit Ethernet Stackable Switch
The factory default login username and password is admin.
@
Notice:
For security reason, please change and memorize the new username and password after this
first setup.
Welcome to PLANET SGSW-2620
User Name: admin
Password:
＊＊＊＊＊
Copyright 2004 (c) PLANET Technology Corp.
- 13 -
Advertisement
Table of Contents
