Trunking - Planet sgsw-2620 User Manual

OObject
Port
Select the port by scroll the list in Port column.
State Allow disable or enable each port of SGSW-2620.
Negotiation
Allow set each port of SGSW-2620 run at Auto or Force mode.
Speed Allow set each port of SGSW-2620 run at 10Mbps or 100Mbps mode.
Duplex Allow set each port of SGSW-2620 run at half-duplex or full-duplex mode.
Flow control Allow disable (OFF) or enable (ON) flow control in full-duplex mode.
Back Pressure Allow disable (OFF) or enable (ON) backpressure in Half Duplex mode.
Band Width The port1 ~ port 24, supports port ingress and egress rate control. For example, assume
port 1 is 10Mbps, allow to set it's effective egress rate 1Mbps and ingress rate 500Kbps. The
switch will perform flow control or Back Pressure to confine the ingress rate to meet the
specified rate.
In: fill in the port effective ingress rate. The valid range is 0 ~ 999. The unit is 100K. 0:
disable rate control. 1 ~ 999: valid rate value.
Out: fill in the port effective egress rate. The valid range is 0~999. The unit is 100K. 0:
disable rate control. 1 ~ 999: valid rate value.
Priority
This static priority based on port, if set the port is high priority, income frame from this port
always high priority frame.
When the port is in security mode, the port will be "locked" without permission of address
Security
learning. Only the incoming packets with SMAC already existing in the address table can be
forwarded normally. User can disable the port from learning any new MAC addresses, and
then use the static MAC addresses screen to define a list of MAC addresses that can use
the secure port.
Table 5-5 Descriptions of the SGSW-2620 Switch Port controls Web Page screen Objects

5.4.5 Trunking

This section displays the screen for trunking a group of ports together to speed up data transmission. The
available items are Aggregator Setting. Aggregator information. State Activity. The Trunking screen in
5-16 appears.
Description
Figure 5-16 SGSW-2620 Trunking Web Page screen
Figure
- 77 -