Logging In To The Ap Using Telnet - Huawei AP8030DN Installation And Maintenance Manual

Huawei AP8030DN & AP8130DN
Hardware Installation and Maintenance Guide

3.3 Logging In to the AP Using Telnet

This section describes how to log in to the AP using Telnet. After logging in to the AP, you can
configure the AP using commands.
1.
2.
3.
4.
5.
3.4 Logging In to the AP Using a Web Client
Pre-configuration Tasks
Before configuring users to log in to the AP using HTTP, complete the following task:
Configure reachable routes between the terminal and the AP.
Issue 02 (2014-12-05)
NOTE
The Telnet protocol poses a security risk, and therefore the STelnet V2 protocol is recommended.
Connect a PC to the ETH/PoE interface of the AP using a network cable.
Configure a static IP address for the PC. The IP address must be in the same network
segment as the AP's IP address. After completing the configuration, ping the AP's IP address
from the PC. If the ping operation succeeds, the connection is set up successfully. If the
ping operation fails, check whether the network cable is faulty.
NOTE
l The IP address 169.254.1.1 and subnet mask 255.255.0.0 have been configured on VLANIF 1 of the
AP before the delivery, and GE0/0/1 has been added to VLAN 1 by default.
l If the AP working in Fit AP mode is online on the AC, the DHCP server automatically assigns an IP
address to the AP. You can remotely log in to the AC on a local terminal and run the display ap-run-
info id ap-id command to check the AP's IP address.
Enter the command line interface on the PC. For example, in Windows XP, choose Start
> Run and enter cmd in the displayed dialog box.
Use Telnet to log in to the AP.
Enter the default user name and password. The default user name is admin, and the default
password is admin@huawei.com. If the user view is displayed, you have logged in
successfully. You are advised to change the user name and password on your first login.
NOTE
You can run the quit command to exit from the Telnet window. When the system fails to exit from the
Telnet window:
l If you logged in to the AP from an AC or a switch, press Ctrl+T to return to the AC or switch view.
This operation does not affect AP services.
l If you logged in to the AP from a PC, directly close the Telnet window. This operation does not affect
AP services.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Logging In to the AP
38