Table of Contents
Advertisement
Huawei AP8030DN & AP8130DN
Hardware Installation and Maintenance Guide
Figure 2-6 Installing a directional outdoor antenna against a pole
outdoor antenna
Figure 2-7
Figure 2-7 Outdoor AP installation scenarios
Installing an omnidirectional outdoor antenna against a pole
Pay attention to the following points when installing an omnidirectional antenna:
1.
2.
3.
4.
Issue 02 (2014-12-05)
Lightning rod
Antenna support
Directional
Antenna pole
Parapet
Height of parapet > 1.2 m
shows outdoor AP installation scenarios.
An omnidirectional outdoor must be installed on a pole with a diameter of 30 mm to 50
mm and the thickness must be at least 2.5 mm. A 50 mm diameter pole made of round steel
is usually used.
The top of pole must be aligned with the hose clamp at the bottom of the antenna.
The antenna must be installed at a proper height to provide sufficient signal coverage, and
the top of the antenna must be within the 45 degrees protection angle of the lighting rod.
Do no weld a lightning rod directly on the antenna pole (there should not be metal subjects
within 1 m around an omnidirectional antenna). Instead, install an independent lightning
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Flat steel
Connect to
earth mat
Height of parapet < 1.2 m No parapet
2 AP Installation
Steel wire
Concrete bed
32
Hide quick links:
Advertisement
Table of Contents
