Star TSP700II series Hardware Manual page 36

Adjustment value according to the paper you are using
Paper thick-ness
(μm)
65
75
Paper thick-ness
(μm)
65
75
85
95
105
130
150
C
B
A
Paper roll core
When using the paper roll with a core whose inside diameter (A):ø12, outside diameter
(B):ø18
Detected diameter (C)
(Approx. mm)
Level 1 Level 2
ø23 ø27
When using the paper roll with a core whose inside diameter (A): ø25.4, outside di-
ameter (B):ø32
Detected diameter (C)
(Approx. mm)
Level 1 Level 2
ø36 ø40
Note:
1) The adjuster is factory-set at level 1 on the horizontal
2) The control switch or the memory switch A may be
3) The detected diameter and remained paper length
C
4) If thick paper is used (paper thickness between 100
Level 3 Level 1
ø31 2.5
2.1
Level 3 Level 1
ø44 2.8
2.4
2.1
1.9
1.7
1.4
1.2
layout and level 3 on the vertical/wall-mount lay-
out.
used to switch between the horizontal and vertical
(wall-mount) layouts. For instructions on setting the
memory switch, refer to the separate Specifications
Manual.
given above are calculated values, and there may be
some variances depending on the rolled state of the
paper or the actual mechanism.
μm and 150 μm), the paper roll may loosen and cause
variances in the detected values. Therefore, set the
adjustor to Level 3 for horizontal layout.
– 32 –
Remained paper length
(Approx. m)
Level 2
4.9
4.2
Remained paper length
(Approx. m)
Level 2
6.4
5.5
4.9
4.4
4.0
3.2
2.8
Level 3
7.7
6.7
Level 3
10.4
9.0
7.9
7.1
6.4
5.2
4.5