Adjusting Of The Foot Bracket; Back Inclination - Vermeiren SAGITTA Instruction Manual

3.7

Adjusting of the foot bracket

3.7.1 Length of the foot bracket
L
Risk of injury – Make sure that before using the foot bracket the
WARNING:
screws are tightened by hand.
L
Risk of damage – Avoid that the foot bracket make any contact with
CAUTION:
the ground. Keep a minimum distance from 30 mm (1.18 in.) above the ground.
Adjust the length of the foot bracket as follow:

1. Loosen screw
2. Adjust the length of the foot bracket to a comfortable length.
3. Tighten the screw
Do not switch the tubes of the foot bracket.
3.8

Back inclination

The tilt angle of the back is adjustable from -7° to 7° for each back tube separately.
at the end of the foot support frame on the left and right side.

on both sides by hand.
Turn the button on the bottom of the back to the left,
the back tube adjusted to the rear.
Turn the button on the bottom of the back to the right,
the back tube moved forward.
Make sure that the two back tubes have a uniform
slope.
Adjust the angle of the back only when the back is
unloaded.
Page 18
Sagitta, Sagitta SI
2011-05