Vermeiren SAGITTA Instruction Manual page 18

Change the seat height and seat angle according the following steps
to change the diameter of the rear wheels skip the first four steps):
1.
Remove the rear wheels (see § 2.11).
2. Change the diameter of the rear wheels.
3. Mount the rear wheels.
4. Check if the axle bushings are fastened well.
5. Screw the swivel axles of the front wheels loose.
6. Choose the correct diameter for the front wheels (refer to table 3).
7. Place the front wheels in the right hole of the front fork (table 3).
8. Install the swivel axles of the front wheels and tighten them. Check the tension in the
swivel axle so it turn smoothly, but there is no space for motion.
9. If installed properly the swivel axles of the front wheels and the ground must be
perpendicular. Check this.
10.
Adjust the brakes according § 3.5.
The Vermeiren Sagitta SI can be adjusted in 3 different seat angles without changing wheel
diameters and front wheel forks.
Seat depth
330 - 420 mm (12.99 - 16.54 in.)
330 - 380 mm (12.99 - 14.96 in.)
420 mm (16.54 in.)
330 - 420 mm (12.99 - 16.54 in.)
330 - 420 mm (12.99 - 16.54 in.)
330 - 420 mm (12.99 - 16.54 in.)
Seat angle (standard-table 3) + 0°
Seat angle (standard-table 3) + 2°
Seat angle (standard-table 3) + 1°
Seat angle (standard-table 3) + 3°
Table 4: Adjustable seat angles for the Sagitta SI
Page 16
(When it is not necessary
Seat angle
Do not use
Do not use
1. Loosen screw .
2. Remove screw .
3. Adjust the seat angle to the desired
position. (refer to table 4)
4. Retighten screws  and .
Sagitta, Sagitta SI
2011-05
Hole
1
2
2
3
4
5