Seat Cover; Back Cover - Vermeiren SAGITTA Instruction Manual

To unfold the back:
1. Pull to the back until it clicks into position.
Be sure that both safety pins  clicks in the hole of the backrest adjustment plate.
2.

2.14 Seat cover

L
Risk of injury – Check that all the 4 straps are secured with Velcro.
WARNING:
The seat cushion from the Sagitta models can be adjusted by a harness system and a
different tension can be transferred to the seat cushion.

2.15 Back cover

L
Risk of injury – Check that all straps are secured with Velcro.
WARNING:
The back of the model Sagitta can be adjusted in its flexibility, so the back of the user is
supported differently.
Below the seat cushion are four clamping systems that
are secured with Velcro, the tension of the seat can be
adjusted.
1. Loosen the 4 fasteners.
2. Pull the respective belt in the desired position.
3. Put the respective belt back on the Velcro and
press this by hand to each other.
1. Remove the back cushion with the velcro by
pulling first to the back and then to the front.
Now you can see the suspension system with
three straps that can be adjusted
independently.
2. Loosen the velcro closures of the respective
straps.
3. Pull the respective strap to the desired position,
the tension of the individual belts can be varied
and the desired support of the back can be set.
4. Place the back cushion again starting from the
front to the back and secure the Velcro
connections by pressing lightly on the back
cushion with your hand.
Page 13
Sagitta, Sagitta SI
2011-05