First-Time Use Without Filter Cartridge Activation; Determining The Water Hardness - Jura ENA Micro 9 One Touch Instructions For Use Manual

1 Preparing and using for the first time
T Fill the water tank with fresh, cold water and
reinsert it.
T Place a receptacle (at least 500 ml) under the
hot-water and dual spout.
k T Press the Rotary Switch.
FILTER RINSING
the hot-water spout.
E You can interrupt rinsing of the filter at any
time by pressing any button. Press the
Maintenance button c, to continue with
rinsing of the filter.
E The water may be slightly discoloured. This
is not harmful to health and does not affect
the taste.
Rinsing of the filter stops automatically.
SYSTEM FILLING
the dual spout.
HEATING
, the system rinses itself. The
RINSING
operation stops automatically.
READY
First-time use without filter cartridge
activation
g T Turn the Rotary Switch until
/
FILTER -
k T Press the Rotary Switch.
OK
16°dH
g T Turn the Rotary Switch to change the water
hardness setting, e.g. to
k T Press the Rotary Switch.
OK
FILL WATER TANK
40
micro 9
, water flows out of
, water flows out of
is displayed.
NO -
.
25°dH
T Remove the water tank.
T Fill the water tank with fresh, cold water and
reinsert it.
PRESS RINSE
T Place a receptacle under the dual spout.
c T Press the Maintenance button.
SYSTEM FILLING
with water.
HEATING
, the system rinses itself. The
RINSING
operation stops automatically.
READY

Determining the water hardness

You can find out what the water hardness is by
using the Aquadur® test strip supplied as standard.
T Hold the test strip briefly (for one second)
under running water.
T Shake off the water.
T Wait for about one minute.
T You will then be able to read the degree of
water hardness from the discolouration of
the Aquadur® test strip and the description
on the packaging.
The water hardness can now be adjusted.
, the system fills up