Inserting And Activating The Filter - Jura ENA Micro 9 One Touch Instructions For Use Manual

5 Maintenance
T Reassemble the milk system, noting the
numbering on the parts.
T Insert the assembled individual parts into
the dual spout and press them together.
T Fit the dual spout on the machine. It will
click into place audibly.

Inserting and activating the filter

Your ENA no longer has to be descaled if you are
using the CLARIS Blue filter cartridge. If you did not
activate the filter cartridge the first time you used
the machine, you can do this now as follows.
E Perform the 'inserting the filter' operation
without any interruptions. This will ensure
that your ENA always produces its best.
Precondition:
READY
k T Press and hold the Rotary Switch until
appears.
RINSE
g T Turn the Rotary Switch until
displayed.
k T Press the Rotary Switch to enter the
programme item.
NO -
g T Turn the Rotary Switch until
displayed.
50
1
2
3
is displayed.
FILTER -
is
YES p
k T Press the Rotary Switch to confirm the
setting.
OK
INSERT FILTER
T Remove and empty the water tank.
T Open the filter holder.
T Insert the filter cartridge into the water tank,
exerting slight pressure.
T Close the filter holder. It will click into place
audibly.
E After two months, the filter will cease to
work. Set the date on the date plate on the
filter holder in the water tank.
T Fill the water tank with fresh, cold water and
reinsert it.
T Place a receptacle (at least 500 ml) under the
hot-water spout.
c T Press the Maintenance button.
FILTER RINSING
the hot-water spout.
E You can interrupt rinsing of the filter at any
time by pressing any button. Press the
Maintenance button c, to continue with
rinsing of the filter.
E The water may be slightly discoloured. This
is not harmful to health and does not affect
the taste.
is
Rinsing of the filter stops automatically.
HEATING
READY
The filter is now activated.
, water flows out of