First-Time Use Without Filter Cartridge Activation; Determining The Water Hardness - Jura IMPRESSA A5 One Touch Instructions For Use Manual

1 Preparing and using for the first time
k T Press the Rotary Switch.
FILTER RINSING
the hot-water spout.
E You can interrupt rinsing of the filter at any
time by pressing any button. Press the
Maintenance button c, to continue with
rinsing of the filter.
E The water may be slightly discoloured. This
is not harmful to health and does not affect
the taste.
Rinsing of the filter stops automatically.
SYSTEM FILLING
the dual spout.
HEATING
RINSING
, the system rinses itself. The
operation stops automatically.
READY
First-time use without filter cartridge
activation
g T Turn the Rotary Switch until
NO - is displayed.
k T Press the Rotary Switch.
OK
16°dH
g T Turn the Rotary Switch to change the water
hardness setting, e.g. to
k T Press the Rotary Switch.
OK
FILL WATER TANK
T Remove the water tank.
40
, water flows out of
, water flows out of
FILTER - /
25°dH .
T Fill the water tank with fresh, cold water and
reinsert it.
PRESS RINSE
T Place a receptacle under the hot- water
spout and the dual spout.
c T Press the Maintenance button.
SYSTEM FILLING
with water.
HEATING
RINSING , the system rinses itself. The
operation stops automatically.
READY

Determining the water hardness

You can find out what the water hardness is by
using the Aquadur® test strip supplied as standard.
T Hold the test strip briefly (for one second)
under running water.
T Shake off the water.
T Wait for about one minute.
T You will then be able to read the degree of
water hardness from the discolouration of
the Aquadur® test strip and the description
on the packaging.
The water hardness can now be set.
, the system fills up