6. Connect one end of a 40-pin
IDE cable to the IDE connector
on the drive. Connect the other
end to an availble IDE
connector on the motherboard.
Each drive tray has a designated IDE cable to ensure better air flow
and cable placement. Make sure to connect the appropriate cable plug
to each drive.
7. Connect a 4-pin power plug to
the drive power connector.
8. Repeat steps 1 to 7 to install
other hard disk drives.
2-14
6
Chapter 2: Hardware setup
7
8
Need help?
Do you have a question about the 5U Tower Chassis Kit AK34 and is the answer not in the manual?
Questions and answers