Table of Contents
Advertisement
2.8
Connecting the cables
The chassis includes power and signal cables that you need to connect to
the motherboard and to the devices that you will install.
Most of the cables for the chassis kit are already connected upon
shipment. When installing system devices and connecting cables,
make sure that all cables are routed properly for better system stability
and performance. Refer to the picture below when arranging cables.
Standard cables connected to the motherboard
1.
Chassis fan
2.
8-pin 12V AUX power
3.
24-pin ATX power
4.
Primary IDE
5.
Secondary IDE
Refer to the motheboard user guide for detailed information on the
connectors.
2-22
1
3
8
6.
Tertiary IDE
7.
Floppy disk drive
8.
20-pin system panel
9.
Front USB connector
Chapter 2: Hardware setup
2
4
5
6
7
9
Advertisement
Table of Contents
Need help?
Do you have a question about the 5U Tower Chassis Kit AK34 and is the answer not in the manual?
Questions and answers