Toshiba e-STUDIO203S Service Manual page 86

Main Sub
Contents
code code
5 02 Fusing lamp, cooling fan
operation check (HT LAMP
CHK)
03 Copy lamp ON check
(C-LAMP CHK)
6 01 Paper feed solenoid
(CPFS1, CPFS2, MPFS)
operation check (PSOL
CHK)
02 Resist roller solenoid (RRS)
operation check (RES.R
SOL CHK)
7 01 Check of warm-up display
and aging with JAM (W-UP/
AGING)
[Function]
When [ENTER/START] key is pressed, the fusing lamp repeats ON for 500ms and OFF for
500ms 5 times. During this period, the cooling fan motor rotates.
[Operation]
1) Initial display
05-02 HT LAMP CHK
EXECUTING...
[Function]
When [ENTER/START] key is pressed, the copy lamp turns ON for 5sec.
[Operation]
1) Initial display
05-03 C-LAMP CHK
EXECUTING...
[Function]
When [ENTER/START] key is pressed, the selected paper feed solenoid repeats ON for 500ms
and OF for 500ms 20times.
← →
When [ / /10KEY] is pressed, the paper feed solenoid setting is switched.
Code number
0
1
2
[Operation]
1) Initial display
06-01 PSOL CHK
0:CPFS1
→
2) [ /10KEY]
06-01 PSOL CHK
1:CPFS2
[Function]
When [ENTER/START] key is pressed, the resist solenoid repeats ON for 500ms and OFF for
500ms 20 times.
[Operation]
1) Initial display
06-02 RES.R SOL CHK
EXECUTING...
[Function]
Copying is repeated to make the set quantity of copies.
When the test command is executed, warm-up is started and warm-up time is added for every
second from 0 and displayed.
When warm-up is completed, addition is stopped. When [CA] key is pressed, the ready lamp
lights up.
After that, enter the copy quantity with [10KEY] and press [ENTER/START] key to repeat copy-
ing of the set quantity (interval 0sec).
To cancel the test command, turn off the power or execute a test command which causes hard-
ware reset.
[Operation]
1) Initial display
07-01 W-UP/AGING
e-STUDIO203S/203SD TEST COMMAND, TROUBLE CODES 10 - 5
Details of function/operation
Setting
CPFS1
CPFS2 Operation is possible only when No. 2 cassette is installed.
MPFS
←
2) [ /10KEY]
06-01 PSOL CHK
2:MPFS
3) [ENTER/START]
06-01 PSOL CHK
EXECUTING...
4) Returns to the initial display.
2) After 10sec
07-01 W-UP/AGING
0
Remark
10