Table of Contents
Advertisement
Installation
EN
Connecting the heating element to the control
box
INFO
Never bend the temperature sensor line.
Connect the colour-coded temperature sensor to the
bottom of the Tepan cooktop using the relevant slot.
Remove the cover plate of the temperature sensor slot
X
X
by pushing the springs together.
Insert the corresponding temperature sensor into the
X
X
matching coloured slot.
Ensure that the temperature sensor is engaged in the
X
X
slot straight.
To secure the temperature sensor, insert the cover
X
X
plate from the back into the slot.
Ensure that the cover plates are positioned tightly
X
X
against the housing.
5.6
Power connection
Observe all safety and warning information
X
X
(see the Safety chapter).
Observe all national and regional laws and regulations
X
X
as well as the supplementary regulations of the local
utility companies.
INFO
INFO The power connection may only be es-
tablished by a certified specialist. He/she also
assumes responsibility for the proper installa-
tion and commissioning.
The power supply line for use (pre-assembled) must be at
least Type H05VV-F or H05VVH2-F.
Cross-section: 3G2.5 mm² with 1-phase connection
Q
Q
Cross-section: 4G2.5 mm² with 2-phase connection
Q
Q
If the connection line has been damaged this must be
Q
Q
replaced by a special connection line. This may only
be done by an authorized member of the After Sales
Service team.
Establishing the power connection
Switch off the main switch/automatic circuit breaker
X
X
before connecting the cooktop.
Protect the main switch/automatic circuit breaker
X
X
from being switched on without permission.
Make sure the device is not energised.
X
X
Only connect the cooktop using a permanent
X
X
connection to a power supply cable.
16
1
2
L1
L2
220 - 240 V~
220 - 240 V~
Fig. 5.16 Connection diagram 2-phase
1
2
L1
220 - 240 V~
Fig. 5.17 Connection diagram 1-phase
Create the connection between the cooktop and the
X
X
control box.
Verify that the installation was done correctly.
X
X
Switch on the main switch/automatic circuit breaker.
X
X
Put the cooktop into operation
X
X
(see the Operation section).
Check all the functions are working correctly.
X
X
5.7
Handover to user
Once installation is done:
Explain the important functions to the user.
X
X
Explain all safety-relevant aspects of operation and
X
X
handling to the user.
Provide the user with the accessories and operating
X
X
and installation instructions to be kept in a safe place.
3
N
PE
3
N
PE
www.bora.com
Advertisement
Table of Contents
