Remove the server blade release lever.
8.
To replace the component, reverse the removal procedure.
Release button
To remove the component:
Power down the server blade (on page 23).
1.
Remove the server blade (on page 24).
2.
Remove the access panel
3.
Remove all hard drives
4.
Remove all hard drive blanks
5.
Remove the hard drive backplane
6.
Remove the front panel/hard drive cage assembly
7.
33).
Remove the system board
8.
Removing DIMMs, heatsinks, processors, and mezzanine cards is not required for this procedure.
("Access
panel" on page 25).
("Hard
drive" on page 26).
("Hard drive
blank" on page 26).
("Hard drive
("System
board" on page 45).
backplane" on page 32).
("Front panel/hard drive cage
Removal and replacement procedures 55
assembly" on page