Remove the thermal interface protective cover from the heatsink.
2.
CAUTION:
To avoid damage to the system board, processor socket, and screws, do not
overtighten the heatsink screws. Use the wrench supplied with the system to reduce the possibility
of overtightening the screws.
Align and install the heatsink. Alternate tightening the screws until the heatsink is seated properly.
3.
Install the front panel/hard drive cage assembly
4.
33).
Install the hard drive backplane
5.
Install the hard drives
6.
Install the hard drive blanks
7.
Install the access panel
8.
Install the server blade.
9.
("Hard drive
backplane" on page 32).
("Hard
drive" on page 26).
("Hard drive
blank" on page 26).
("Access
panel" on page 25).
("Front panel/hard drive cage
Removal and replacement procedures 39
assembly" on page