DIMM baffles
To remove the component:
Power down the server blade (on page 23).
1.
Remove the server blade (on page 24).
2.
Remove the access panel
3.
Remove the DIMM baffle.
4.
To replace the component, reverse the removal procedure.
DIMMs
IMPORTANT:
mix these two types causes the server to halt during BIOS initialization.
To identify the DIMMs installed in the server blade, see "DIMM identification (on page 67)."
To remove the component:
Power down the server blade (on page 23).
1.
Remove the server blade (on page 24).
2.
Remove the access panel
3.
Remove all DIMM baffles
4.
("Access
panel" on page 25).
This server blade does not support mixing RDIMMs and UDIMMs. Attempting to
("Access
panel" on page 25).
("DIMM
baffles" on page 29).
Removal and replacement procedures 29