HP ProLiant BL465c
© Copyright 2007 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The
only warranties for HP products and services are set forth in the express
warranty statements accompanying such products and services. Nothing
herein should be construed as constituting an additional warranty. HP shall
not be liable for technical or editorial errors or omissions contained herein.
Part Number 454507-001
October 2007 (First Edition)
Installation of a server blade requires the following steps:
Install and configure an HP BladeSystem c-Class
Install any server blade options.
Install interconnect modules in the enclosure.
Connect the interconnect modules to the network.
Install a server blade.
Complete the server blade configuration.
For definitions of the acronyms used in this document, refer to
"Acronyms and abbreviations" in the server blade user guide.
Installing an HP BladeSystem c-
Before performing any server blade-specific procedures,
install an HP BladeSystem c-Class enclosure.
The most current documentation for server blades and other
HP BladeSystem components is available at the HP website
Documentation is also available in the following locations:
Documentation CD that ships with the enclosure
HP Business Support Center website
HP Technical Documentation website
Installing server blade options
Before installing and initializing the server blade, install any
server blade options, such as an additional processor, hard
drive, or mezzanine card. For server blade options
installation information, see the HP ProLiant BL465c
Generation 5 Server Blade User Guide on the Documentation
CD or on the HP website
Installing interconnect modules
For specific steps to install interconnect modules, see the
documentation that ships with the interconnect module.