DFI 748-AL User Manual page 77

IRQ 8 Break Suspend
When this field is enabled, access to IRQ 8 will cause the system
to wake up from the Suspend mode.
Ring Power Up Control
This field is used to enable or disable the Wake-On-Ring and Wake-
On-LAN function.
•
Wake-On-Ring - When enabled, the system will power-on to re-
spond to calls coming from an external modem.
•
Wake-On-LAN - When enabled, the LAN card in the system
will allow the network to power-on a Soft Power Down (Soft-
Off) PC. However, if your system is in the Suspend mode, you
can wake up the system only through an IRQ or DMA inter-
rupt. Your LAN card must support the remote wake up func-
tion. Refer to "Wake-On-LAN Connector" in chapter 2 for
more information.
MACPME Power Up Control
This field is used to enable the Wake-On-LAN function of the
onboard LAN.
PCIPME Power Up Control
Enabled This field should be set to Enabled only if your PCI
card such as LAN card or modem card uses the PCI
PME (Power Management Event) signal to remotely
wake up the system.
card will cause the system to wake up.
card's documentation for more information.
Disabled The system will not wake up despite access to the
PCI card.
USB Port Wake Up Control
This field, when enabled, allows you to use a USB device to wake
up the system.
BIOS Setup
Access to the LAN card or PCI
3
Refer to the
77