Table of Contents
Advertisement
2.6.8 Wake-On-LAN Connector
Your LAN card package should include a cable. Connect one end
of the cable to the wakeup header on the card and the other
end to location J16 on the system board. The network will detect
Magic Packet and assert a wakeup signal to power-up the system.
Refer to the add-in card's manual for details. Note: Your LAN card
must support the remote wake up function.
Important:
The 5VSB power source of your power supply must support
≥ 720mA.
BIOS Setting
To use the Wake-On-LAN function, you must enable the "Ring
Power Up Control" field ("PM Wake Up Events" section) in the
Power Management Setup of the BIOS.
Hardware Installation
Ground
+5VSB
WOL
1
3
2
45
Advertisement
Table of Contents
