M O T I O N A R E A S E; Schedule Set - Comelit 49146 User Manual

ALARM ENABLE: alarm trigger switch. You can be set to off, N.C. or N.O. If users set it to off, the DVR will
ignore the alarm input.
MOTION ENABLE: motion alarm switch. You can be set to on or off. If users set it to off, the motion alarm will
be ignored.
MOTION LEVEL: motion sensitivity level. If the figure in the picture is small, please set to high of very high. The
default is normal.
BUZZER TIME: buzzer sound time when there is a sensor or motion alarm.
SENSOR RECTIME: when a motion or sensor alarm occurred, the DVR record last time, the default is 1 minute.
Note: users should press schedule button after setting up the parameters so to activate the settings.
5.6.1 MOTION AREA SET
Turn the Motion Block ON/OFF.
When the cursor moves to Alarm set, then push enter button, the alarm setup window will appear, which is
illustrated as below. Please push upward, downward, leftward, rightward button to move the cursor and push
enter button to change, long push enter change all value the same as you selected.

5.7 SCHEDULE SET

When the cursor moves to Schedule Set, please push enter button, the schedule setup window will appear,
which is illustrated as below.
You change a recording schedule during a week using this setup, from Monday to Sunday; you can set a
period time in each day.
START: start record time
STOP: stop record time
SUN ÷ SAT: Select the weekday for recording (00:00-23:59)
22