Inspection, Cleaning And Repair Of Cylinder Head Components; Assembly Of Cylinder Head; Inspect Camshafts And Bearings - Toyota 2L-T Repair Manual

ENGINE MECHANICAL
-
Cylinder Head (2L-T)
EM-39
DISASSEMBLY OF CYLINDER HEAD
a
(See page EM-35)
INSPECTION, CLEANING AND REPAIR OF
CYLINDER HEAD COMPONENTS
INSPECT CAMSHAFTS AND BEARINGS
B. Inspect cam lobes
Using a micrometer, measure the cam lobe height.
Standard cam lobe height:
lntake 2L-T 53.450
-
53.470 mm
(2.1043
-
2.1051 in.)
3L 54.290
-
54.310 mm
(2.1374
-
2.1382 in.)
Exhaust 54.990
-
55.010 mm
(2.1650
-
2.1657 in.)
Minimum cam lobe height:
lntake 2L-T 52.95 mm (2.0846 in.)
3L 53.79 mm (2.1177 in.)
Exhaust 54.49 mm (2.1453 in.)
If the cam lobe height is smaller than the minimum,
replace the camshaft.
ASSEMBLY OF CYLINDER HEAD
(See page EM-35)
INSTALL HALF CIRCULAR PLUG
(a)
Remove any old packing (FIPG) material.
(b) Apply seal packing to the half circular plug as shown.
Seal packing:
Part No. 08826-00080 or equivalent
(c) Install the half circular plug to the cylinder head.