Table of Contents
Advertisement
Bleeding the fuel system (diesel engine only)
Driving the vehicle until the fuel tank is
empty is not recommended. Otherwise, air
may be sucked into the fuel system. If this
happens, the ? malfunction indicator
lamp (USA only) or the ± malfunction
indicator lamp (Canada only) comes on
and the engine may not start immediately
after refueling the vehicle.
After refueling:
Make sure the automatic transmission
is set to P.
The gear position indicator in the multi-
function display should be on
Do not depress the accelerator.
i
Vehicles with KEYLESS-GO*: If necessary,
remove the KEYLESS-GO start/stop button from
the starter switch ( page 43).
Turn the SmartKey in the starter switch
to position 2 for at least 10 seconds
( page 41).
Return the SmartKey in the starter
switch to position 0 ( page 41).
Turn the SmartKey in the starter switch
to position 3 ( page 41) and hold it
there for a maximum of 40 seconds or
until the engine runs surge-free.
If the engine does not start:
Wait for approximately 2 minutes.
Turn the SmartKey in the starter switch
to position 3 ( page 41) and hold it
there for a maximum of 40 seconds or
until the engine runs surge-free.
If the engine still does not start, do not
make any further attempts to start the
P
.
engine. Contact an authorized
Mercedes-Benz Light Truck Center or call
Roadside Assistance ( page 335).
i
When the ? malfunction indicator lamp
(USA only) or the ± malfunction indicator
lamp (Canada only) has been illuminated for the
above condition, it will remain illuminated until
the engine was cycled on and off four times in a
row.
Bleeding the fuel system (diesel engine only)
Practical hints
527
Advertisement
Table of Contents
