Table of Contents
Advertisement
Controls in detail
Automatic transmission
Shifting from D or R to N
If you want to select neutral position N
with the transmission being in drive
position D or reverse gear R:
With the vehicle at a standstill, depress
the brake pedal and keep it pressed.
Step firmly on parking brake pedal
( page 67).
i
When the vehicle needs to be moved with
the engine switched off and the transmission set
to neutral position N ( page 192), do not
depress the parking brake pedal.
Move gear selector lever up to resis-
tance point when in drive position D or
down to resistance point when in
reverse gear R to select neutral
position N.
Release the brake pedal.
192
Shifting procedure
The automatic transmission selects indi-
vidual gears automatically, depending on:
drive position D ( page 192) with gear
ranges ( page 197)
the position of the accelerator pedal
( page 195)
the vehicle speed
!
Allow engine to warm up under low load use.
Do not place full load on the engine until the
operating temperature has been reached.
Shift into reverse gear R or park position P only
when the vehicle is stopped.
Avoid spinning of a drive wheel for an extended
period when driving off on slippery road
surfaces. This may cause serious damage to the
drivetrain which is not covered by the
Mercedes-Benz Limited Warranty.
With drive position D selected, you can use
the steering wheel gearshift control
buttons ( page 198) to influence trans-
mission shifting by:
limiting the gear range
changing gears manually
Transmission positions
The current transmission position appears
in the multifunction display.
1 Current transmission position
!
If the current transmission position does not
appear in the multifunction display due to a
malfunction, for example, make sure that the
automatic transmission is in the desired position
by carefully driving off with the transmission in
drive position D.
Do not limit the gear range.
Advertisement
Table of Contents
