Table of Contents
Advertisement
i
You can cancel the procedure by pressing
the LOW RANGE switch again while the indicator
lamp is flashing.
Switching LOW RANGE mode off
(switching from LOW RANGE to HIGH
RANGE)
!
The shift procedure can only be performed
when the following conditions are met:
The engine is running ( page 41).
The automatic transmission is in position N
( page 190).
The vehicle speed does not exceed 43 mph
(70 km/h).
i
There is no reset to LOW after the ignition
has been switched off.
Press LOW RANGE switch 1
( page 202).
Indicator lamp 2 flashes.
If the system senses that all conditions
are met, it will switch to back to
HIGH RANGE mode. A chime sounds
and the LOW RANGE display 3 ap-
pears in the multifunction display.
The indicator lamp 2 on the
LOW RANGE switch goes out, indicat-
ing that the LOW RANGE mode has
been deactivated.
i
You can cancel the procedure by pressing
the LOW RANGE switch again while the indicator
lamp is flashing.
For messages in the multifunction display,
see "Practical hints" section ( page 488).
Controls in detail
Transfer case
203
Advertisement
Table of Contents
