Selecting The Party Program - Viessmann vitocal 300-g Operating Instructions Manual

Changing the room temperature for a few hours...

Selecting the party program

Select the party program if you want to heat spontaneously at the standard room
temperature (e.g. if guests unexpectedly stay longer in the evening).
■ Central heating with the set standard
room temperature.
■ The DHW will be boosted to the set
temperature.
■ The DHW circulation pump is switched
ON.
Note
■ If several heating circuits are installed,
the party program will affect all heating
circuits.
■ If a remote control (e.g. Vitotrol 200) is
connected to a heating circuit where
party mode is enabled, party mode
applies only to this heating circuit.
Party program
Party starts at:
Friday 20.05.08
Party ends at:
Saturday 21.05.08
< > - +
Terminating the party program
Party mode ends automatically with the
next changeover to central heating with
standard room temperature, but no later
than after 8 hours.
Press the following keys:
1. "Device settings"
2. "Date and time"
3. "Party program"
4. {/} for the value to be set
5. -/+ for the required value
6. "OK"
20:00
04: 00
Back OK
If you want to terminate party mode pre-
maturely, press the following keys:
1. "Device settings"
2. "Date and time"
3. "Party program"
Adjusting the room temperature
(cont.)
(beginning / end of
party)
(date and time for begin-
ning / end of party)
to confirm and exit the
menu
The symbol _ appears
in the standard display
when the party program
is enabled (see
page 9).
27