Setting The Time Program For Dhw Heating - Viessmann Vitocal 060-A Operating Instructions For The System User

Selecting an operating program
Outside temperature from –5 °C to 35 °C
0 10
DHW temperature in °C
Fig. 16
Heat pump
A
Immersion heater
B

Setting the time program for DHW heating

In the time program, you specify when DHW is heated
in the "PROG" operating program.
You can define a time program that applies every day
of the week:
"WEEK" Every day of the week
You can define separate time programs for each indi-
vidual day:
"MON" Monday
"TUE" Tuesday
"WED" Wednesday
"THU" Thursday
"FRI" Friday
"SAT" Saturday
"SUN" Sunday
Note
Please note that your DHW heat pump requires some
time to heat the water to the required temperature.
Select a correspondingly earlier start time.
Press the following buttons:
1. until "PROG"
2. OK for 3 s until "WEEK" or "MON" is displayed.
DHW demand
The draw-off profile can be changed from L (2 people)
to XL (4 people) to accommodate a higher DHW
demand or provide greater convenience. Only author-
ised contractors may make this change.
(cont.)
is displayed.
Outside temperature below –5 °C or above 35 °C
0 10
DHW temperature in °C
Fig. 17
Heat pump
A
Immersion heater
B
3. +/− to select a day
or
+ to keep "WEEK".
4. OK to confirm
5. +/− for the selected hour: 00:00 to 23:00 h
6. OK to confirm
DHW heating is enabled during the selected
hour.
7. +/− to select further hours.
8. OK for 3 s to save. "SAVE" appears.
Note
If no key is pressed for 30 s, the program
closes without saving. "EXIT" appears.
Only for selection "MON":
Repeat these steps for the other days.
Note
If the time and day have not yet been set, the heat
pump control unit will ask you to do this. See
page 16.
DHW heating
13