Canon Pixma MP530 User Manual page 141

• Cannot Receive Faxes Automatically
Cause Action
The receive mode displayed on the
bottom left of the LCD is not
<FAXONLY>, <DRPD>*1, <NET
SW.>*2, <ANSMODE>, or <FAX/TEL>.
If <MANUAL> is displayed, you cannot receive faxes unless you pick up
the answering machine's handset and either press [Color] or [Black], or
dial the remote receiving 10.
If you want to receive faxes automatically, which means not having to do
anything when you receive a fax, set the receive mode to <FAX ONLY
MODE>, <DRPD>*1, <NETWORK SWITCH>*2, <ANS.MACHINE MODE>, or
<FAX/TEL AUTO SW> (See "Receive Modes" on page 80).
If the receive mode is <ANS.MACHINE MODE>, connect an answering
machine to the machine (see the Easy Setup Instructions) and check that
a message plays back when the answering machine answers.
*1
This setting is only available in US and Canada.
*2
This setting is not available in some countries and regions.
• Machine Does Not Switch Automatically between Voice and Fax Calls
Cause Action
The receive mode displayed on the
bottom left of the LCD is not
<DRPD>*1, <NET SW.>*2,
<ANSMODE> or <FAX/TEL>.
There will be no automatic sWitchi,!~ between voice and fax .calls unless
the receive mode is set to <DRPD> ,<NETWORK SWITCH> 2,
<ANS.MACHINE MODE> or <FAX/TEL AUTO SW>.
If the receive mode is <ANS.MACHINE MODE>, connect an answering
machine to the machine (see the Easy Setup Instructions) and check that
a message plays back when the answering machine answers.
*1
This setting is only available in US and Canada.
*2
This setting is not available in some countries and regions.
• Quality of Received Fax is Poor
Cause
Action
<ECM RX> is set to <OFF>. Set <ECM RX> to <ON> (See "ECM RX" on page 95).
The sender's original document or The image quality of the fax is mainly determined by the sender's fax
fax machine is dirty. machine. Contact the sender and check whether the scanning area of his/
her fax machine is not dirty.
ECM sending/receiving is not
•
On your machine, set <ECM RX> to <ON> (See "ECM RX" on page 95).
enabled although the line/
•
Contact the sender and check that his/her machine is set to enable
connection is poor.
ECM sending.
• If the sender's or receiver's fax is not ECM-compatible, the fax will be
sent/received in the standard mode.
• Reduce the reception start speed. See "RX START SPEED" on page 96.
• Repeated Errors Occur When You Receive a Fax
Cause Action
The telephone line condition or
connection condition is no good.
The sender's fax machine is not
operating normally.
Reduce the reception start speed (See "RX SETTINGS" on page 95). If
there is a poor line or connection, reducing the reception start speed may
correct the error.
Contact the sender and check whether his/her fax machine is operating
normally.
Chapter 9 Troubleshooting 139