Adjustments; Osd; Ir Cut Filter; Camera Self-Test Function - Santec VTC-8120WDP User Manual

Bedienungsanleitung / User manual
VTC-8120WDP / VTC-8122WDP / VTC-8320WDP / VTC-8322WDPU

2.3. Adjustments

All adjustments are accessible from the outside, thus there is no need to open the camera
housing.

2.3.1 OSD

The camera adjustments are done by an OSD (on-screen-display) menu. On the backside of
the camera you will find a mini-joystick. Press onto this joystick and a menu pops up in the
video picture. You can now move the joystick left/right/up/down in order to get to the desired
menu item. To confirm your selection, press onto the joystick.
See chapter "Camera adjustments via OSD menu" for further details.

2.3.2 IR cut filter

The integrated IR cut filter operates magnetically. If the camera is not power supplied, the
filter is loose and creates a mechanical switching sound when the camera is moved.

2.3.3 Camera self-test function

If the camera is connected to the power supply, it automatically starts a self-test.
status LED
The upper LED indicates the status of the self-test which is shown is shown in the following
colour order:
red  yellow  blue  pink
If the camera operates properly, the LED lights for another approx. 10 sec in blue and then
extinguishes.
In case the camera is defective, the LED shows the colour of the respective error:
red:
yellow:
blue:
In case of an error, please contact your service personnel.
Only do the camera adjustments when the self-test has been completed (after approx.
15 sec).
_________________________________________________________________________________
red  yellow  blue  pink (each for approx. 2 sec)
error with power supply (the camera takes up too much power in order
to operate properly)
no video signal at video output
no errors detected
- 39 -