Santec VTC-8120WDP User Manual page 59

Bedienungsanleitung / User manual
VTC-8120WDP / VTC-8122WDP / VTC-8320WDP / VTC-8322WDPU
L/L Sync (LineLock Synchronsation):
INT: internal synchronisation
LL: LineLock synchronisation
Note: If you use 12 V DC, synchronisation is set to „internal". If you use 24 V AC at 60
Hz, you can also use LineLock synchronsation.
Monitor type:
Change the settings according to your monitor. LCD/CRT monitors can be used.
Factory Reset:
Return to factory settings.
Communication (only for VTC-280IRPWDU):
Protocols:
Camera ID: The camera ID can be set from 0 to 255. Default ID is "1".
Baud rate:
Save/reboot: Save the set values and reboot the camera.
Previous:
Exit:
Save the current settings and return to main menu.
Note: RS-485 (only for VTC-8320WDP and VTC-8322WDPU):
The camera can also be parameterised remotely by using the RJ-45 system
connector via a RS-485 connection. The communication is done via the Pelco D
protocol. The command to open/close and to confirm the camera OSD is "PRESET
95". Using the up/down/left/right commands of the keyboard joystick, you can
navigate through the OSD menu.
_________________________________________________________________________________
Pelco-D is supported by default.
Baud rate can be set to 4800-57600.
Return to main menu.
- 59 -